Aj3 j2 j1 b, Dwyer instruments, inc – Dwyer DPMA-4 User Manual

Page 2

OPERATION
Selecting Engineering Units
Four sets of jumper pins are located in the back of the meter, between the
meter and the adder board. Move the jumper to fit over the appropriate pins
which correspond to the desired engineering units. See Figure 1 Example
shows °C turned on.

Selecting Decimal Point Position
Four decimal point positions are available on the digital process meter, J4-
J7. Move the jumper to correspond to the desired decimal point location.
See Figure 3.

Setting Min/Max Display Value J1, J2, J3 (See Figure 4 & 5):

If:
Min Display is ≤ 0 or
Min Display is > 0 and Max Display Min Display > 5,
Then:

J1, J2 & J3 should be all set to the top jumper. (See Figure 4).

If:
Min Display is > 0 and Max Display Min Display < 5,
Then:
J1, J2, J3 should be all set to the jumper. (See Figure 5).

MAINTENANCE/REPAIR
Upon final installation of the Series DPMA-4, no routine maintenance is
required. The Series DPMA-4 is not field serviceable and should be
returned if repair is needed. Field repair should not be attempted and may
void warranty.

WARRANTY/RETURN
Refer to “Terms and Conditions of Sale” in our catalog and on our website.
Contact customer service to receive a Return Goods Authorization number
before shipping the product back for repair. Be sure to include a brief
description of the problem plus any additional application notes.

DWYER INSTRUMENTS, INC.

Phone: 219/879-8000

www.dwyer-inst.com

P.O. BOX 373 • MICHIGAN CITY, INDIANA 46360, U.S.A. Fax: 219/872-9057

e-mail: [email protected]

Printed in U.S.A. 8/13

FR# R5-443474-00 Rev. 2

Figure 2

Figure 3

Figure

PSI

P Models
PF
KW

P Models
V
A

°F
°C

(13 PIN HEADER)

•

Figure