Dwyer 2500 - Manual (Page 4)

949-1190-1 Page 4 December, 1998
INSTALLATION
Mount the instrument in a location that will not be subject to excessive
temperature, shock, or vibration. All models are designed for mounting in
an enclosed panel.
Select the position desired for the
instrument on the panel.
Prepare the panel by cutting and
deburring the required opening.
From the front of the panel, slide
the housing through the cut out.
The housing gasket should be
against the housing flange before
installing.
From the rear of the panel slide the
mounting collar over the housing.
Hold the housing with one hand
and using the other hand, push the
collar evenly against the panel until the springs are compressed. The
ratchets will hold the mounting collar and housing in place.
MODEL IDENTIFICATION
Model 2 5
Alarm
0 = No
1 = Yes
Input
1 = Thermocouple, J,K,T,E,N,L
2 = RTD, DIN, NIST, Ni 120
Output
1 = SSR
2 = 5 VDC
3 = Relay
5 = Current
It is not necessary to remove the control chassis from
the housing for installation. If the control chassis is
removed from the housing, you must follow industry
standard practice for control and protection against
Electro-Static Discharge (ESD). Failure to exercise
good ESD practices may cause damage to the control.