Crystal nVision Lab Reference - Manual (Page 8)

Module Queries and Commands  6
nVision Programming Instructions
Module Queries and Commands  6
commands
X Water reference
Sets the module to the water reference entered.
MOD:H2O! # 4C
MOD:H2O! # 60F
MOD:H2O! # 68F
Note: This command is only available when the nVision has R080007 or greater firmware and is populated with a pressure (PM) or barometric (BARO) module.
X unit
Changes the module to the unit of measure entered.
Pressure (Pm) & Barometric (Baro) modules
MOD:UNIT! # PSI
MOD:UNIT! # kg/cm2
MOD:UNIT! # inHg
MOD:UNIT! # inH2O
MOD:UNIT! # mmHg
MOD:UNIT! # mmH2O
MOD:UNIT! # kPa
MOD:UNIT! # bar
MOD:UNIT! # mbar
MOD:UNIT! # MPa
MOD:UNIT! # user ... Changes the module to user unit*
* Note: Not for BARO module
resistance temperature module (rtd100)
MOD:UNIT! # C
MOD:UNIT! # F
MOD:UNIT! # R
MOD:UNIT! # K
MOD:UNIT! # Ohm
milliamp modules (ma20)
MOD:UNIT! # mA
MOD:UNIT! # %4-20mA
MOD:UNIT! # %10-50mA
MOD:UNIT! # VDC
MOD:UNIT! # SwitchTest