Introduction, I/o settings – Crystal nVision Lab Reference User Manual
Page 3
Introduction
1
nVision Programming Instructions
—
IntroductIon
Thank you for choosing the nVision Reference Recorder from Crystal Engineering Corporation. Your nVision is a combination of leading edge
technology and rugged industrial design.
We hope your nVision meets your expectations, and we’re interested in any comments or suggestions you may have. You can send us a note at:
Many features in this and our other products are a direct result of your comments!
Digital Interface
The nVision can be connected to a personal computer via mini-USB, using the provided USB cable. The nVision can be operated remotely, as if you were
pressing the buttons. You can use a simple terminal program to send the commands, or, you can incorporate them into your own software program.
I/o Settings
The serial interface settings are:
Baud rate
data Bits
Parity
Stop Bits
Flow control
115200
8
None
1
None