Airlink101 AR685W - Manual (Page 59)

60
please input 80-90; if you want to apply this rule on a single port, just
input the port number, such as 80. If the remote (destination) IP address
and /or port number is universal, just leave it blank.
Traffic Type
Please select the traffic type of this rule, available options are None,
SMTP, HTTP, POP3, and FTP. You can select a specific traffic type for
this rule, if you want to make this rule as a IP address based rule (apply
the limitation on all traffics from / to the specified IP address / port
number), select “None”.
Protocol Please select the protocol type of this rule, available options are TCP
and UDP. If you dont know what protocol your application uses, please
try “TCP” first, and switch to “UDP” if this rule doesn’t seems to work.
After you finish with all settings, please click “Save” button, you’ll be brought back to previous
menu, and the rule you just set will appear in current QoS table; if you did anything wrong, you’ll
get an error message when you click “Save” button, please correct your input by the instructions
given by the error message.
After you finish with all QoS settings, please click “Apply” button.
If you want to reset all settings in this page, please click “Cancel” button.
After you clicked Apply, the following message will be displayed on your web browser:
You can click “Continue” to back to previous setup page to continue on other setup procedures,
or click “Apply” to reboot the router so the settings will take effect (Please wait for about 30
seconds while router is rebooting).