Airlink101 AR685W User Manual
Page 53
54
Add (in red box)
Click on Add button in the red box to save the Special
Application rule you set into the Current Trigger-Port Table.
From the Current Trigger-Port Table, you can select each Special Application setting by checking the
“Select” checkbox.
Parameter
Description
Delete
If you want to delete a setting, check the ‘select’ box of the
setting you want to delete, then click ‘Delete’ button. (You can
select more than one setting).
Delete
All
If you want to delete all settings listed here, please click ‘Delete
All’ button.
Reset
You can also click ‘Reset’ button to unselect all.
After you finish with all settings, please click “Apply” button.
If you want to reset all settings in this page, please click “Cancel” button.
After you clicked Apply, the following message will be displayed on your web browser:
You can click “Continue” to back to previous setup page to continue on other setup procedures,
or click “Apply” to reboot the router so the settings will take effect (Please wait for about 30
seconds while router is rebooting).