Badger Meter ORION Classic (CE) - Manual (Page 2)

WELCOME
Badger
®
ORION
®
SERIAL REPEATER PROGRAMMER
Welcome to the Badger ORION Serial Repeater Programmer (RP) software. The RP
software allows you to easily define a set of transmitters that a ORION Repeater must repeat.
The software also provides you with the means to verify that the Repeater is hearing all of the
needed transmitters, and that the Repeater is being heard at the receive destination.
The RP software runs on a PC under Windows
®
2000 Professional or Windows XP. It
provides you a simple way to work with your Badger ORION Repeater:
• You can easily load the list of transmitter serial numbers into the Repeater.
• You can change the list of transmitters in a Repeater that is currently working by
adding a new transmitter serial number, removing one that is no longer needed, or
changing an incorrect serial number.
• You can clear out the list of transmitter serial numbers if you wish to remove a
Repeater from service.
• You can verify that the transmitters that are to be repeated are within range and
are being received.
• You can verify that the repeated transmissions are being received at the target
location.
REPEATER INSTALLATION
PRODUCT UNPACKING AND INSPECTION
Upon receipt of the product, perform the following unpacking and inspection
procedures:
Note: If damage to the shipping container is evident
upon receipt, request the carrier to be present
when the product is unpacked.
Carefully open the shipping package, follow any instructions that may be marked
on the exterior. Remove all cushioning material surrounding the product and
carefully lift the product from the package.
2