Aleco Clear-Flex II with Walkin Mounting System - Manual

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE
2720 E. Avalon Ave. Muscle Shoals, AL 35661 ● Phone (256) 248-2402 or toll free 1-800-633-3120
Fax: 1-800-750-9616 ● email: [email protected] ● web: www.aleco.com
P/N 477239
1110
Diagram 1
Mount Bracket
Diagram 2
Install Carriage Bolts
Diagram 3
Walk-In System
Installation Instructions
TOOLS NEEDED
• Pen or Pencil to Mark Holes
• Drill
• Crescent Wrench
• Step Stool or Ladder
• Utility Knife to Cut Strips
IMPORTANT
Prior to installation, unroll all door strips and place them on
a clean, flat surface in a warm atmosphere for a minimum of
twenty-four (24) hours. This will allow the strips to return to
their original form.
1. Mount pre-drilled Walk-In Mount to wall above
door. Use fasteners supplied by others for
mounting (Diagram 1).
2. Next, slide all the 3/8” carriage bolts down the
slot of aluminum mounting hardware (Diagram 2).
3. Starting at the left, place the first clear inside strip
(A) on the first two bolts keeping in mind the
concave pattern in Diagram 4 below. Place the
second inside strip (B) on the third and fourth
bolts and continue down the entire length
accordingly (Diagram 3).
4. Again starting at the left and using the concave
pattern, place the first outside strip (C) on the
second and third bolts. The next outside strip will
fit on the fourth and fifth bolts. Continue this
down the entire length accordingly (Diagram 3).
5. Place all washers and bolts onto screws and
tighten finger tight (Diagram 3).
6. The first strip on left is to be flush with the edge
of the aluminum hardware. Starting at this point
with the nut, tighten securely with tool. Next, take
second nut in hand and pull to the right to secure
the strip flat against the aluminum hardware.
Tighten second nut with tool. Continue this
pattern until all strips are flat and smooth and all
bolts are securely tight.
7. The strips should be initially trimmed to give a
minimum of ¼” clearance using a utility knife.
The door strips need to hang for 24 to 28
hours before the final trim to allow for proper
alignment.
Diagram 4