Thermo Fisher Scientific Alpha CON 100 - Manual (Page 22)

19
6. Setting to Factory Default
All the controller settings and user-defined password, except
calibration data will be cleared when you enter into the “Usr”
“Clr” menu.
Press both the ▲ and ▼ keys
simultaneously while you are in any
mode menu. The unit requests for the
password if it was set previously.
Enter the password and press
ENTER. The display will show “CLr”.
Press ENTER to confirm. The display
will blink briefly - the password is
reset to its factory default and toggles
to its measurement mode.
The Master Password is “555” and
default user set password is “000”.
The Master Password can be used
even if any other password was set
previously.
Key the master password “555” after entering into the “Ënt”
“id” display, you will see “Usr” and “Clr” display alternately.
Press ENTER to confirm and the display returns to its
measurement mode.
SETUP
MODE
ENTER
Ent
SETUP
MODE
ENTER
id
SETUP
MODE
ENTER
CLr