Thermo Fisher Scientific Alpha CON 100 - Manual (Page 18)

15
5.4.2 The Hi HYS Menu
1. Enter this menu by pressing the
MODE key to the “SEt” display if
you are in the measurement
mode.
2. Press ENTER key. If the
password has been set earlier,
key in the password using the
method described in section 4.1.
Press ENTER once to confirm.
After you set the correct
password, you see the “CAL”
and “COn” display blinks
alternatively. Press ▼ key thrice,
the display shows “Hi” “HYS”
blinking.
3. Press ENTER key to access the
Hi HYS menu and the display
shows the last Hi HYS value or
default (2% of Full Scale). Use ▲
and ▼ keys to change the value
of the Hi HYS point.
4. Press ENTER to confirm the
value of the Hi HYS.
5. Press MODE key to exit to
measurement mode. You can
press MODE key (as an
ESCAPE key) to revert to the
measurement value if ENTER is
not pressed; the set value is not
stored into memory.
SETUP
MODE
ENTER
Hi
SETUP
MODE
ENTER
02
SETUP
MODE
ENTER
HYS
NOTE : The maximum
value of Hysteresis is
4% of its Full Scale
(FS) selected. The HI
HYS hysteresis is
spread equally on
either side of the Hi
SET point.