Thermo Fisher Scientific Alpha CON 100 - Manual (Page 16)

13
ATC OFF : If a PT 100 is not used,
then the ATC should be set to OFF.
In step 3 above, choose by pressing
▲
and ▼ keys to select ATC OFF.
Then press ENTER. The display
will now show the default of 25
o
C or
the last set value (blinking). Use ▲
and ▼ keys to set your desired
value. Press ENTER to confirm and
the display shows “CAL” “Con”.
Note : For ATC OFF, you can adjust
the set temperature values from 0.0
to 99.9
o
C. This value will be used
for its temperature compensation
e.g. Conductivity in the MTC mode.
SETUP
MODE
ENTER
A t c
SETUP
MODE
ENTER
OFF
SETUP
MODE
ENTER
25.0