Thermo Fisher Scientific CyberComm Pro for CyberScan DO 1500 - Manual (Page 16)

Instruction Manual CyberComm DO 1500
12
Icon 11: Meter Settings
See Figure 16.
Program your meter functions via this icon on
CyberComm Program.
a) Temperature
I) Temperature Units of Measurement
- Select °C or °F as required (Default is
°C)
b) Pressure
I) Pressure
- Select from a range of 425 to 850
mmHg (Default is 760 mmHg)
c) Salinity
I) Salinity
- Select from a range of 0.0 to 45.0 ppt
(Default is 0.0 ppt)
d) Calibration
I) Saturation Calibration Points
- Select ONE or TWO (Default is TWO)
II) Calibration Mode
- Select AUTO or MANUAL (Default is
MANUAL)
e) Stability
Check box to enable the Stability Indicator
f) Good Laboratory Practice Settings
Enter the relevant information for useful future references.
g) Reset Saturation calibration settings to default
Check box & click apply to reset Saturation calibration settings.
h) Reset Concentration (mg/L) calibration settings to default
Check box & click apply to reset Concentration (mg/L) calibration settings.
Click on OK or Apply to save settings whenever there are changes. Click CANCEL to exit without making
any changes.
Figure 16: Meter Settings