Thermo Fisher Scientific Eutech DO 6 Plus - Manual (Page 13)

Instruction Manual DO 6+
- 7 -
2.8 Switching the Meter On
Press ON/OFF to power up your meter. Your meter will
cycle through various setup parameters when switched on.
1) All LCD segments will briefly illuminate.
2) The model [DO 6+] will display next along with mg/l,
ppm, and % annunciators.
3) Next, the meter revision number [r #.##] is shown
briefly before beginning measurement.
4) The meter begins with the measurement mode that
was in use when it was previously powered off ⎯%,
mg/l, ppm, or T.
2.9 Changing Mode
Press MODE to switch between percentage saturation (%), concentration
(mg/L)(ppm), and temperature (T) measurement.
CAL 13 CAL 24
mg/l
NTU
ppm
%pH
TAvg
mg/l
ppm
%
ON
OFF
A
%
mg/l
A
TA
A
%
MODE
MODE
MODE
Percentage Saturation
Concentration Mode
Temperature Mode
Automatic Temperature
Compensation