AMX Radia Eclipse 4-Channel Dimmer Module RE-DM4 - Manual (Page 53)

AMX RADIA Lighting Programming
45 RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules
Ramp Preset Down (NEW)
This function ramps down the specified or currently active (last recalled) preset until the ramp is stopped or the
all dimmers in the preset reach 0%.
 If is not specified, then the last recalled preset is ramped.
 Note this function uses the 'PS' command to stop ramping.
 The ramp rate for this function is the default ramp time as established by the 'RT' command.
Stop Ramping Preset (NEW)
This function stops the ramping of the specified or currently active ramping preset.
 If is not specified, then the last recalled preset is stopped.
Recall Preset
This function recalls the specified preset over an optionally specified time.
 If time is not specified, then the rate used when saving the preset used.
 If no rate was specified when saving the preset, then the current default preset rate is used (as set by
the "PT" command).
Record Preset
This function records the current level of all "defined" dimmers and associates them with the specified preset.
 An optional time parameter may be specified to record the specified rate at which the preset is to be
recalled.
 If time is not specified, then the default preset rate value at the time of the preset recording will be
used when recalling the preset as set by the "PT" command.
Ramp Preset Down
Command: PD
Response: None
Examples: SEND_COMMAND Radia,'PD' Ramp last preset down
SEND_COMMAND Radia,'PS' Stop ramping.
SEND_COMMAND Radia,'PU43' Ramp preset 43 down
SEND_COMMAND Radia,'PS43' Stop ramping preset 43
Stop Ramping Preset
Command: PS
Response: None
Examples: SEND_COMMAND Radia,'PS' Stop ramping last preset
SEND_COMMAND Radia,'PS32' Stop ramping preset 32
Recall Preset
Command: RPT[]
Response: None
Examples: SEND_COMMAND Radia,'RP2' Recall preset 2 at the saved rate
SEND_COMMAND Radia,'RP56T10' Recall preset 56 over 10 seconds
Record Preset
Command: SPT[]
Response: None
Examples: SEND_COMMAND Radia,'SP3' Record preset 3 at default rate
SEND_COMMAND Radia,'SP32T3' Record preset 32 with 5 second ramp