Seametrics IP800-Series User Manual
Page 6
Page 6
INSTALLATION
Caution:
These flow sensors are not recommended for installation down-
stream of the boiler feedwater pump where installation fault may expose the
flow sensor to boiler pressure and temperature. Maximum recommended
temperature is 130°F (Plastic), 200°F (Metal).
FULL PIPE RECOMMENDATIONS
Possible Problem:
Allows air pockets to form at sensor
Better Installation:
Ensures full pipe
Possible Problem:
Post-valve cavitation can create air pocket
Better Installation:
Keeps pipe full at sensor
Possible Problem:
Air can be trapped
Better Installation:
Allows air to bleed off
See also other documents in the category Seametrics Equipment:
- EX800-Series (12 pages)
- EX100-200-Series (16 pages)
- IP100-200-SERIES (12 pages)
- TX800-Series (12 pages)
- TX100-200-SERIES (12 pages)
- PE102 (4 pages)
- SEB (2 pages)
- SES (4 pages)
- S-Series (4 pages)
- MJ-Series (4 pages)
- MJN-Series (4 pages)
- WJ-Series (4 pages)
- WT-Series Turbine (4 pages)
- iMAG-Series (16 pages)
- WMX-Series (12 pages)
- WMX-Series (8 pages)
- WMP-Series (8 pages)
- AG2000-Series (4 pages)
- AO55 (4 pages)
- FT400-Series (12 pages)
- DL76 (4 pages)
- FT500-Series (8 pages)
- FlowInspector (16 pages)
- RSP5 (4 pages)
- PT35 (4 pages)
- PT34 (4 pages)
- PS40 (2 pages)
- PD10 (4 pages)
- PC-SERIES (4 pages)
- AD30 (2 pages)
- AG1000 (10 pages)
- AG2000 v.1 (4 pages)
- AG2000 v.2 (4 pages)
- AO45 (4 pages)
- DL75 v.1 (4 pages)
- DL75 v.2 (24 pages)
- EM 100-102 v.1 (4 pages)
- EM 100-102 v.2 (4 pages)
- EM 101 v.1 (6 pages)
- EM 101 v.2 (8 pages)
- EX100-200 Series v.1 (14 pages)
- EX100-200 Series v.2 (16 pages)
- EX80 Series v.1 (12 pages)
- EX80 Series v.2 (12 pages)