NSi Industries K801Z - Manual (Page 9)

43b. Load Number #
Signal Duration
Sec. # #
Is This OK?
Answer YES if the information is correct.
44. Do You Want to Set or Review Load Outputs?
PRESS YES for additional signal timer loads or PRESS NO to proceed.
DAYLIGHT SAVING
45. Is Standard Time OK?
PRESS NO if your area has daylight saving time. PRESS YES only if your area does NOT use daylight
saving time, and proceed to Step #51.
46. Is Daylight Saving OK?
PRESS YES.
47. Is U.S. option OK?
This is automatic daylight saving. It will advance 1 hour on the first Sunday in April and turn back 1 hour
on the last Sunday in October. If this applies to your area
PRESS YES and unit will proceed to Step #51.
If not, PRESS NO.
48. Enter Spring Date
Any date may now be entered for the beginning of daylight saving.
PRESS ENTER.
49. Enter Fall Date
Any date may now be entered for the end of daylight saving.
PRESS ENTER.
50. Unit will review Spring and Fall dates and ask IS THIS OK? PRESS YES, If correct. If not, PRESS NO
and enter new Spring and Fall dates.
AM/PM or 24 HOUR FORMAT
51. Is AM/PM format OK?
PRESS YES for standard AM/PM format. PRESS NO if 24 hour military format is desired. Then PRESS
YES.
CLEAR ALL MEMORY
52. Do You Wish to Clear All Memory?
CAUTION: If YES is PRESSED, unit will ask if you are sure. If YES is PRESSED again, ALL MEMORY
WILL BE DELETED.
ENTER HOLIDAY SCHEDULE FOR SINGLE DATES
Inserting a holiday schedule is the same as assigning a normal weekly schedule to a load. However, a holiday
schedule should be entered after all other schedule entries are completed. One schedule will apply to all single
date holidays. Holidays will be effective for all loads. If no schedule is entered for holidays for any load, it will
remain OFF during the holiday.
Proceed to the mode for REVIEW OR SET SCHEDULES.
PRESS YES.
Enter load number(s) to be assigned. All previous entries will be reviewed by the unit. Continue to press YES
until unit asks for another schedule entry.
PRESS YES.
8