NSi Industries K801Z - Manual (Page 8)

After you answer YES to one of the above questions, the display then shows:
37. Sunset PM ##:##
Enter Offset Min
Input how many minutes (1 to 99) before or after sunset you want Astro-On to occur, then
PRESS
ENTER, or enter two zeros if no offset is desired.
38. After Sunset?
PRESS NO if you want lights to come ON before sunset. Otherwise, PRESS YES. After you answer YES
to one of the preceding questions, the Astro settings are reviewed. The display shows:
39. Load Number #
S M — — — F — H
— 2 3— — 6 — —
OFF # # Min After or Before Sunrise
ON # # Min After or Before Sunset
Is This OK?
Answer YES if the information is correct. If you answer NO, all Astro settings are deleted. Enter new
settings.
40. Another Load?
If you want to set or re-schedule another load number,
PRESS YES and follow above steps.
Programming is complete. You may review or re-program an Astro load, or program a new Astro load by
returning to above steps.
ASTRONOMIC WITH STANDARD ON/OFF SCHEDULE
If you desire to have astronomic ON at sunset and time switch OFF at a preset time, then ON again during the
night and astronomic OFF at sunrise, see: REGULAR SCHEDULING procedures. Schedule an OFF at night
and an ON before sunrise.
NOTE: DO NOT set an AM ON AFTER 2:30 A.M. ABOVE 50 DEGREES NORTH
LATITUDE.
IMPORTANT NOTES:
Astro loads can also be reviewed in the Schedule/Set Review Mode. It cannot however, be altered or deleted
in this mode.
Duty Cycling may not be set for loads assigned to Astro.
Astro-ON and Astro-OFF times are automatically adjusted for Daylight Saving Time.
Normal ON/OFF schedules for an Astro channel are set in schedule review. ANY ASTRO LOAD CARRIES
PAST MIDNIGHT AUTOMATICALLY.
LOAD OUTPUTS (SIGNAL TIMER)
41. Do You Want to Set or Review Load Outputs?
PRESS YES if required. If not, PRESS NO and proceed to Step #45.
ENTER LOAD NUMBER for which you would require a signal timer.
PRESS ENTER.
42. Maintained Output. Is this OK?
PRESS NO since signal output is required.
43. Signal Output. Is this OK?
PRESS YES.
43a. Enter Duration in Seconds.
Use the numbered keys to set the signal duration (1-99 seconds.) PRESS ENTER.
7