NSi Industries DG280A-24 - Manual (Page 8)

6
Follow the same procedures above to set the second
signal or duty cycle entries .
Press MODE key to advance to next screen .
6.0 SCHEDULE SET MODE
Press MODE key until display shows:
6.1 SETTING HOURS AND MINUTES
Note: A schedule is needed for each event . If a typical
ON/OFF pair is required, use SCH 01 for the ON
event and SCH 02 for the OFF event .
Press the HOUR, and MIN keys to set the desired time .
Press EVENT to set desired event
(ON or OFF, C1, or C2)
Note: C1 or C2 will not be displayed if the duty cycle
durations are not set in Step 5 .
Press CH SELECT key to select channel on
DG280A .