NSi Industries DG280A-24 - Manual (Page 12)

10
8.0 REVIEW, MODIFY AND DELETE
Press MODE to advance to any of the following
MODES:
1 . AUTO MODE: In this automatic mode, the unit will
execute the scheduled programs . Time, day, seconds
and load status are displayed . C1or C2 is displayed
when Duty Cycle is programmed and operating .
OVERRIDE IN AUTO MODE: The load status of the
channel can be manually changed by pressing the
OVRD key (or OVR1 and OVR2 key for DG280A) .
The unit will stay in this position until the next scheduled
event . A flashing LCD load indication (ON, OFF) shows
the status was changed by the override not a scheduled
event .
Press the OVRD (or OVR1 and OVR2 key for
DG280A) key until ON or OFF stops flashing to return
to programmed setting .
OVERRIDE IN MAN MODE: The load status of the
channel can be manually changed by pressing the
OVRD key (or OVR1 and OVR2 key for DG280A) .
The unit will stay in this position until OVRD is pressed
again . A flashing LCD load indication (ON, OFF)
shows the status was changed by the override not a
scheduled event .
3 . CLK MODE: To change the current time press
HOUR and MIN to modify existing settings . Press
ENTER to save changes .
4 . DATE MODE: Press MONTH, DATE and YEAR to
modify existing settings . Press ENTER to save
changes . DAY is automatically adjusted .
5 . DSt MODE: Factory default is set at US standard
daylight savings dates noted by ON . To remove
daylight savings time setting from, press DEL to change