NSi Industries DG280A-24 - Manual (Page 13)

11
screen to show OFF . DST may be activated again by
pressing DEL . Press ENTER to save changes . To change
the from the standard DST month/week/day setting
press HOUR and refer to step 4 .1 .
6 . CYCLE MODE: To change duty cycle timing, press
either the HOUR, MIN, or SEC keys . Press ENTER to
save changes .
7 . SCH MODE: To change schedule, press ENTER to
advance to desired event . Press HOUR, MIN, EVENT
to modify time settings . Press DEL to delete . Press
ENTER after each modification to save changes .
8 . SKIP MODE: Press D/ON, D/OFF and DAY to
modify existing settings . Press ENTER to save
changes .
NOTES:
1 . Unit has a look back feature . Press the EVENT key
once (or twice for two circuit units) to activate current
schedule then EVENT key again to return to the
time (run) screen . Unit will automatically pick up the last
schedule .
2 . To clear date and time only and provide unit with
a soft reboot, press and release the reset button that is
recessed under the small hole to right side of LCD
screen .
3 . To clear all memory, while in the RUN mode, press
ENTER, display will show:
Use the EVENT key to display: