Martel Electronics DMC1410 - Manual (Page 39)

Table 6: Calibrator Commands
Command Description
CAL_START Puts the calibrator in calibration mode
CJC_STATE Turns CJC on or off.
CJC_STATE? Returns the state of the CJC
CPRT_COEFA Sets the custom RTD coefficient A
CPRT_COEFA? Returns the custom RTD coefficient A
CPRT_COEFB Sets the custom RTD coefficient B
CPRT_COEFB? Returns the custom RTD coefficient B
CPRT_COEFC Sets the custom RTD coefficient C
CPRT_COEFC? Returns the custom RTD coefficient C
CPRT_MIN_T Sets the custom RTD minimum temperature
CPRT_MIN_T? Returns the custom RTD minimum temperature
CPRT_MAX_T Sets the custom RTD maximum temperature
CPRT_MAX_T? Returns the custom RTD maximum temperature
CPRT_R0 Sets the custom RTD R0 resistance
CPRT_R0? Returns the custom RTD R0 resistance
FAULT? Returns the error code of an error that has occurred
FREQ_LEVEL Sets the frequency and pulse amplitude
FREQ_LEVEL? Returns the frequency and pulse amplitude
FREQ_TYPE Set the frequency output to continuous (frequency) or
pulse.
FREQ_TYPE? Returns frequency output type, continuous or pulse
FREQ_UNIT Sets the unit for frequency and pulse
FREQ_UNIT? Returns the unit for frequency and pulse
FUNC? Returns the current mode of the upper and lower display
GET_CLOCK Returns the calibrator date and time setting
GET_SN Returns the calibrator serial number
LOCAL Returns user to manual operation of the calibrator
LOCKOUT Locks out the keypad of the calibrator, and allows for
remote operation only
LOWER_MEAS Sets the mode for measuring on the lower display.
L_PRES_UNIT Sets the pressure unit on the lower display
OUT Sets the output of the calibrator
OUT? Returns the output of the calibrator
PRES? Returns the model and serial number of the attached pres-
sure module
37