MAGURA HS33 (2013) - Manual (Page 9)

THE PASSION PEOPLE
10
If you are the proud owner of a MAGURA suspension fork with FIRM-tech equipment,
mounting the brakes is a breeze. Fit the fork and mount the brake lever to the handlebar as
described. Fit the slave cylinders of the brake as shown on page 18 of this manual.
1. Check out the double quick release comfort! To open it push the quick
release in direction of the wheel; you can now move the brake cylinder to change your wheel
or the brake pads. Quick release tension is adjusted similar to standard version
(c.f. page 8)
2. Close the quick release: Push the brake cylinder back towards the fork. Close the
quick release by doing the same. That’s all!
A booster is not necessary with FIRM-tech and not foreseen either. It is not possi-
ble to mount one!
3. Adjust the brake pads to the rim width with the 5 mm allen screw which is integrated
in the brake cylinder. By turning the screw clockwise the pad approaches to the rim.
4. With FIRM-tech you adjust the brake pad to the rim on both sides with the 5 mm
allen screw.
Shorten the hose and pad wear adjustment as described in the respective chap-
ters!
7. Installation of FIRM-tech® models
FELGEN 2011 E.indd 9 07.06.2011 17:08:31 Uhr