MAGURA HS33 (2013) - Manual (Page 12)

Español
Italiano
Nederlands
Français
English
Deutsch
1. brake pad wear adjustment HS 33
Turn the red Turbo Pad Adjuster (TPA) in “+” direction. Pads move towards the rim.
MAGURA brakes do not need any special maintenance after correct installation.
Regular bleeding is absolutely not necessary, because the MAGURA Blood mineral oil
does not contract water like DOT brake liquid used in cars, on motorcycles and competitors’
products.
Brake pad wear adjustment as shown above.
When
it is time to change the pads.
Before changing the pads you must always screw back the TPA to their start position!
2 New (1) and worn (2) brake pad. When your brake pads are worn as shown it is
time to change them.
3. To change the brake pads, open the quick release, remove the brake from the
canti stud, pull out the old pad and then just snap in a new one. After removing the wheel, pull
out the old pad and snap in a new one on the other side. That’s all!
9. Maintenance/ brake pad change
13
1
2
FELGEN 2011 E.indd 12 07.06.2011 17:08:39 Uhr