KYORITSU 6010B - Manual (Page 4)

― 2 ―
returned to your distributor for attention.
14. Do not operate the function switch while the instrument is connected to a
circuit. If, for example, the instrument has just completed a continuity test
and an insulation test is to follow, disconnect the test leads from the circuit
before moving the function switch.
15. Do not rotate function switch when test button is depressed. If the function
switch is inadvertently moved to a new function when the test button is
depressed or in lock-down position the test in progress will be halted. To
reset, release test button and press again to restart testing on new function.
16. THE WIRING CHECK LED (P-E, P-N) of this instrument is to protect the user
from electrical shock resulting from incorrect connection of Line and Neutral
or Line and Earth.When the Neutral and Earth conductors are incorrectly
wired, the WIRING CHECK LED function cannot identify the incorrect
connection. Other procedures and test must be conducted to check and
confirm that the wiring is correct prior to making measurement. Do not use
this instrument to check the correct wiring of the power supply. Kyoritsu will
not be held liable for any accident that may result from incorrect wiring of
the power supply line.
17. Use a damp cloth and detergent for cleaning the instrument. Do not use
abrasives or solvents.
CAT.Ⅲ
Caution, risk of electric
shock
Protection against wrong
connection is up to 440V
Caution (refer to accompanying
instruction manual)
Earth Ground
protected throughout by DOUBLE INSULATION or REINFORCED
INSULATION
Designed to protect against transient overvoltages in a building
wiring installation (low-voltage distribution level)
Symbols used on the instrument