KYORITSU 2009R - Manual (Page 24)

̶ 22 ̶
 DANGER
●Never use the instrument on a circuit above 750VAC/1000VDC.
This may cause electrical shock hazard and damage to the
instrument or the circuit under test.
● Do not make measurement with the battery compartment cover
removed.
● Do not make measurement with the test leads plugged into the
instrument.
● Keep your fingers and hands behind the barrier during
measurement.
① The PEAK mode is available on DCA, ACA, DCV and ACV
ranges.
Set the function selector switch to the desired position.
Note： Only on DCA range, press the Zero Adjust/Reset button
for about one second to zero adjust the reading with the
transformer jaws closed.
② Press the mode selector button twice to enter from the normal
mode to the PEAK mode. "PEAK" should be shown on the display.
③Follow instructions for DCA, ACA, DCV or ACV measurement.
Note： For accurate reading, press the Zero Adjust/Reset button to
reset the reading after clamping onto the conductor or making
test lead connections to the circuit under test. Then, proceed
to measurement.
Peak Hold
INPUT Current