KROHNE BM 100A EN - Manual (Page 5)

Installation and operating instructions BM 100 A 5
Standard nameplate
Items supplied
• signal converter connected to a cable, coaxial or rod signal guidance probe
Optional: remote extension with wall support, sunshade (with fastening material in each case)
• bar magnet for operator control / parameter assignment (only in version with local display)
• wrench for the covers
Documentation supplied
• installation instructions: detailed user manual and reference book.
• approval documents, unless reproduced in the installation and operating instructions.
Product liability and warranty
The BM 100 A TDR level gauge is designed solely for measuring the distance, level, interface and
volume of liquids, pastes, slurries, solids and particulate materials.
The BM 100 A TDR level gauge does not form part of an overfill protection system as defined in
WHG nor is it concerned by the Pressure Equipment Directive (PED) 97/23/EC.
Special codes and regulations apply to its use in hazardous areas.
Responsibility as to suitability and intended use of these level gauges rests solely with the user.
Improper installation and operation of our level gauges may lead to loss of warranty.
In addition, the "General conditions of sale", found on the back of the invoice and forming the basis
of the purchasing contract, are applicable.
If you need to return the device to the manufacturer or supplier, please refer to the information
given at the end of this manual.