KROHNE OPTIWAVE 8300C Marine ATEX EN - Manual (Page 18)

4
START-UP
18
OPTIWAVE 8300 C
www.krohne.com 02/2009 - 4000407102 - AD ATEX OPTIWAVE 8300 R02 en
Start-up
• Are the wetted components (gasket, flange and antenna) resistant to corrosion by the tank
product?
• Does the information given on the nameplate agree with the application?
• Did you connect the equipotential bonding system correctly?
• Ex d applications:
Ex d applications: Ex d applications: Ex d applications: Are the cable entries, plugs and adaptors Ex d-approved?
• Ex i applications: Ex i applications: Ex i applications: Ex i applications: Are you using an intrinsic barrier within the correct parameters? Refer to the
"Ex i equipment" section. The electrical circuit characteristics must not be more than the
maximum intrinsically-safe values.
• Did you install the correct cable entries? Is the terminal compartment correctly sealed?
• Does the optional purging system agree with Ex requirements?
WARNING!
Make sure that it is safe to supply electrical power. Do a start-up check:
AD_ATEX_OPTIWAVE8300_EN_090407_4000407102_R02_PRT.book Page 18 Tuesday, April 7, 2009 5:07 PM