KROHNE BM 700 EN - Manual (Page 10)

Page 10 BM 700 Installation and Operating Instructions
Configuration menu (version 5.00 / 5.01)
Function (Fct.) Input range Description
1.0 OPERATION
1.1 DISPLAY
1.1.1 FCT.DISP identical with 3.2.1
1.1.2 UNIT.LENGTH identical with 3.2.2
1.1.3 UNIT.CONV. identical with 3.2.3
2.0 TEST
2.1 HARDWARE
2.1.1 MASTER Master hardware test.
2.1.2 DISPLAY Display hardware test.
2.1.3 STATUS Status information for Service
2.2 CUR.OUTP.I
2.2.1 VALUE I Value display Display of actual value of the current
output.
2.2.2 TEST I Select 2 mA/4 mA/6 mA/...
... 20 mA/22 mA Output of selected value to the current
output. With safety query.
2.4 FIRMWARE
2.4.1 MASTER Display Display of master firmware version.
2.4.2 DISPLAY Display Display of display firmware version.
3.0 INSTALL.
3.1 BASIS.PARAM
3.1.1 TANKHEIGHT Select unit m/cm/mm/
inch/Ft
Enter
0.50 ... 20.00 [m] Enter tank height (see explanatory
notes).
The unit entered here is also used for
all other length entries.
3.1.2 BLOCKDIST Enter
0.10 [m] ... tank height Enter block distance = non-measurable
range below bottom edge of flange (see
explanatory notes).
3.1.3 ANTENNA Select STANDARD
WAVE-STICK Select antenna type. WAVE-STICK for
all Wave-Stick versions, except type
"SW" for stillwells. All other =
STANDARD.
3.1.4 ANT.EXTENS. Enter 0.00 [m] ... tank height Enter length of antenna extension.
3.1.5 DIST.PIECE Enter 0 ... 2000 [mm] Enter length of distance piece above
flange (high temperature version =
120
mm).
3.1.6 STILLWELL Select NO / YES
If “YES“: enter 25 ... 200 [mm] Selection: without or with still well.
With still well: enter inside diameter in
[mm] (compensates different wave
speeds in still wells)
3.1.7 REF.OFFSET Enter -10.00...0...+10.00 [m] Reference offset is added to measured
distance values.
3.1.8 TB.OFFSET Enter -100.00...0...+100.00 [m] Tank bottom offset is added to
measured level values.
3.2 DISPLAY
3.2.1 FCT.DISP Select LEVEL
DISTANCE
CONVERSION Select function of display
(value to be displayed).
(see also explanatory notes)
3.2.2 UNIT.LENGTH Select m/cm/mm/
inch/Ft/
PERCENT/BARGRAPH Select unit for length value to be
displayed (only for level and distance).
3.2.3 UNIT.CONV. Select m3/l(Liter)/US Gal/
GB Gal/Ft3/bbl/PERCENT/
BARGRAPH/USER UNIT Select unit for conversion value to be
displayed (“volume table“).
(see explanatory notes)
3.2.4 USER UNIT Text entry
10 characters Enter user-defined unit for the
conversion table.
3.2.5 ERROR MSG. Select NO/YES Select whether error messages to be
shown in display.