KROHNE OPTIFLEX 2200C SIL - Manual (Page 25)

SERVICE
8
25
OPTIFLEX 2200 C
www.krohne.com 01/2013 - 4000738603 - AD SIL OPTIFLEX 2200 R03 en
8.6 Troubleshooting
If you find a problem, please contact your local representative. If the device must go back to the
manufacturer, refer to "Returning the device to the manufacturer" in this supplement.
8.7 Returning the device to the manufacturer
8.7.1 General information
This device has been carefully manufactured and tested. If installed and operated in accordance
with these operating instructions, it will rarely present any problems.
INFORMATION!
• Modifications to the device are not permitted.
• Only approved personnel can repair the device.
CAUTION!
Should you nevertheless need to return a device for inspection or repair, please pay strict
attention to the following points:
• Due to statutory regulations on environmental protection and safeguarding the health and
safety of our personnel, manufacturer may only handle, test and repair returned devices that
have been in contact with products without risk to personnel and environment.
• This means that the manufacturer can only service this device if it is accompanied by the
following certificate (see next section) confirming that the device is safe to handle.
CAUTION!
If the device has been operated with toxic, caustic, flammable or water-endangering products,
you are kindly requested:
• to check and ensure, if necessary by rinsing or neutralising, that all cavities are free from
such dangerous substances,
• to enclose a certificate with the device confirming that is safe to handle and stating the
product used.