KROHNE OPTISENS PAC 050 EN - Manual (Page 7)

Manual OPTISENS PAC 050
7 OPTISENS PAC 050
1. Mechanical installation
On chapter 9.2 you will find detailed instructions for the installation.
For panel-type meters you have to prepare an opening of 92 x 92 mm / 3.6” x 3.6”. Install the device and fix it
with the two mounting clips which were part of the delivery.
You can install devices in wall-mounting enclosures either by hanging them upon the center slot or by sliding
the slot under a screw, which is an alternative for limited space. Either way you have to fix it additionally with
two screws.
ATTENTION
Install the device in a place where it is not put under mechanical or chemical strain!
Mind the protection class:
• Panel mounting version: IP 54 (front), IP 30 (Housing)
• Wall mounting version: IP 65 (closed terminal cover)
1.1 Installation of panel-mounting converters
Prepare an opening of 92 x 92 mm / 3.6” x 3.6”.
Install the device from the front side and fix it with the
two mounting clips which were part of the delivery.
Screw tight until the device is fixed perfectly.