KROHNE CAPAFLUX EEx-ATEX EN User Manual

Page 20

CAPAFLUX IFM 5080 K/CAP-EEx and CAPAFLUX IFM 5080 K/CAP i-EEx

5.2

Replacement of electronics unit

Display unit of IFC 090 / CAP…-EEx

Refer to the standard Installation and
Operating Instructions for detailed
information about resetting and
reprogramming the new electronics unit
after replacement. The customer specific
data (like the value of the internal
totalizer) are stored in DATAPROM IC-18,
which must be transferred from the "old"
to the "new" electronics unit. See Sect.
8.7 of the standard Installation and
Operating Instructions for detailed
information.

Before commencing work, note the instructions in Sect. 5.1,

“Before opening".

Then continue as follows:

1. Remove the display cover of the electronics compartment.
2. Unscrew the two screws A (M3) of the display unit (see figure above) and turn it carefully aside.
3. Disconnect the

2-pole

field circuit connector (item B in figure on last page) and the

10-pole

electrode

circuit connector (item C). See figures in Sect. 5.1 and the following.
4. Unscrew the two mounting screws D of the electronics unit and unscrew SE, which fixes the copper
ground strip to the back of the housing. A screwdriver with a long shaft (

≥ 200 mm) is most suitable for

unscrewing screw SE (e.g. screwdriver type Philips No. 2).
5. Carefully remove the electronics unit of the converter housing (see the remark below).
6. Check if the voltage setting (only applicable for AC power supplies) and power fuse rating are correct
on the new electronics unit. If necessary, change the voltage setting or replace the power fuse (see
Sect. 5.3 and 5.4 of this manual).
7. Carefully insert the electronics unit (keep cables aside, see remark below). Then mount the unit
completely into the housing and fix the screws. First the two screws D, then screw SE and reconnect
the

2-pole

field circuit connector B and the

10-pole

electrode circuit connector C to the right counter-

plugs on the electronics unit (see figure in Sect. 5.1).
8. Finally screw the display unit back on the frame of the electronics via the two screws A.
9. Screw the cover of the electronics compartment back into the housing.

Note the instructions of Sect. 5.1 ("After opening") during reassembling.

IMPORTANT !

Carefully keep the connecting cables of the field coil and electrode circuits to the
side of the housing, while removing respectively inserting the electronics unit into
the signal converter housing. This is to prevent damaging of the connecting
cables!