KROHNE SMARTSENS PH 8320 EN - Manual (Page 41)

DESCRIPTION OF HART INTERFACE
7
41
SMARTSENS PH 8320
www.krohne.com 11/2013 - 4002543902 - MA SMARTSENS PH 8320 R02 en
4 Device Information Sensor information Order code
Device name
Serial number
HART ® ID
Polling address
Manufacturer ID
Date of manufacturing
SW version
HW version
Calibration Slope
Offset
Inner buffer
Buffer solution 1
Buffer solution 2
No. of calibrations
SIP counter
CIP counter
Autoclaving counter
Operating parameters
(OP)
Commissioning date
Operating hours
OP time > 80°C / 176°F
OP time > 110°C / 230°F
OP time < -300mV
OP time > +300mV
Max. temperature
Temp. compensation
Manual temp.
Commissioning Set date of commissioning
5 Service
1 Service calibration Trimming at 4 mA (+/-)
Trimming at 20 mA (+/-)
2 Service parameter Reset of sensor
Load factory setting
3 Password Password protection Activate or deactivate the password protection.
Select between on and off.
Password operator Set password for operator
Password
administrator
Set password for administrator
Reset password Reset all passwords (only administrator)
4 Sensor lock Select between YES YES YES YES or NO NO NO NO to lock the sensor.
If you select YES YES YES YES the setting is not reversible anymore and the sensor is
invalid for use. The HART ® communication is not possible anymore.
.book Page 41 Monday, November 18, 2013 10:42 AM