KROHNE OPTISENS PH 8300 EN - Manual (Page 24)

4
OPERATION
24
OPTISENS PH 8300
www.krohne.com 04/2012 - 4001926701 - MA OPTISENS PH 8300 R01 en
3 or 4
pages,
scrolling
with ↓ or ↑
> 2.5
s
^
B test B test B test B test >
^
B1 sim.process inp.A >
^
B1.1 temperature >
^
For further
information
see function
tables.
B1.5 ORP
Only if switched to ORP! Only if switched to ORP! Only if switched to ORP! Only if switched to ORP! (for
dual channel version; refer to
pH/ORP sensor documentation
for further information)
B1.7 pH
(for dual channel version; refer
to pH/ORP sensor
documentation for further
information)
B2 sim.process inp.B B 2.1 temperature
B2.5 ORP
Only if switched to ORP! Only if switched to ORP! Only if switched to ORP! Only if switched to ORP!
(for dual channel version; refer
to pH/ORP sensor
documentation for further
information)
B2.7 pH
(for dual channel version; refer
to pH/ORP sensor manual for
further information)
B3 simulation I/O B3.1 current out A
B3.2 current out B
B3.3 current out C
B3.6 simulation R3
B4 actual values B4.1 operating hours
B4.2 process input A
B4.2.1 temperature
B4.2.2 pH/ORP
B4.2.9 CPU temp. (depends on V
number)
B4.2.11 electrode current
B4.3 process input B
B4.3.1 temperature
B4.3.2 pH/ORP
B4.3.9 CPU temp. (depends on
V number)
B4.3.11 elctrode current
B5 logbooks B5.1 status log
B5.2 calibration log
B6 information B6.1 C number
B6.2 process input A
B6.3 process input B
B6.4 SW.REV.MS
B6.5 SW.REV.UIS
B6.6 Electronic Revision ER
↓↑ ↓↑ ↓↑ ↓↑
Measuring
mode Main menu Submenu Parameter
.book Page 24 Tuesday, July 3, 2012 2:56 PM