AT&T DECT CL84309 - Manual (Page 27)

21
Telephone settings
Answering system settings
To delete your outgoing announcement:
1. When the handset is in idle mode, press
MENU/
SELECT
to enter the main
menu.
2. Press
MENU
/SELECT again.
3. Press q CID or DIRp to scroll to >ANS SYS SETUP, then press
MENU
/SELECT.
4. Press q CID or DIRp to scroll to >ANNOUNCEMENT, then press
MENU
/SELECT, the system announces, “To play, press 2. To record, press 7.”
5. Press 3 to delete your recorded announcement. The system announces
“Announcement deleted.”
When your announcement is deleted, the system answers calls with the pre-
recorded announcement described on the previous page.
Number of rings
You can set the answering system to answer an incoming call after two, four,
or six rings. You can also select toll saver, which is explained below. Unless you
change it, the answering system answers an incoming call after four rings.
To set the number of rings on a cordless handset:
1. When the handset is in idle mode, press
MENU/
SELECT
to
enter the main menu.
2. Press
MENU
/SELECT again.
3. Press q CID or DIRp to scroll to >ANS SYS SETUP, then
press
MENU
/SELECT.
4. Press q CID or DIRp to scroll to ># OF RINGS, then press
MENU
/SELECT.
5. Press q CID or DIRp to scroll and choose among 2, 4, 6 or
TOLL SAVER.
Toll saver - the answering system answers a call after two
rings if you have new messages, and after four rings when
there are no new messages. This feature allows you to check
for new messages and avoid paying long distance charges
when calling from out of your local area.
6. Press
MENU
/SELECT to confirm your setting. A confirmation
tone sounds.
NOTE: If you subscribe to voicemail services through your telephone service provider, see
Answering system and voicemail on page 55.
>
ANS. SYSTEM
DIRECTORY
>
ANS SYS SETUP
PLAY MSGS
>
# OF RINGS
REMOTE CODE
# OF RINGS
2