beautypg.com

Installation – KROHNE OPTISWIRL 4070 Quickstart EN User Manual

Page 12

background image

2

INSTALLATION

12

OPTISWIRL 4070

www.krohne.com

06/2010 - 4000122102 - QS OPTISWIRL R04 en

2.3.6 Turning the display

Turn the display as follows:

• Disconnect the power supply from the measuring device.
• Unscrew the cover in front of the display 1 from the connection housing.
• Pull the display 2 carefully a few centimetres out of the anchor fitting and turn it to the

required position 3.

• Press the display onto the spacer pins 4, until it clicks.
• Turn the cover with gasket 5 back onto the housing and tighten it by hand.

DANGER!
All work on the device electrics may only be carried out by appropriately trained personnel. The
regional occupational health and safety directives must always be observed.

INFORMATION!
If the measuring device is installed in a vertical pipe, you will have to turn the display by 90°; if
installed below a pipe, turn 180°.

Figure 2-7: Turning the display

QS_OPTISWIRL4070_R04_en_122102_PRT.book Page 12 Monday, June 7, 2010 8:51 AM