KROHNE VA 40-VA 45 EN - Manual (Page 5)

SAFETY INSTRUCTIONS
1
5
VA40 - VA45
www.krohne.com 09/2013 - 4000424402 MA VA40 45 R04 en
Safety instructions
1.1 Intended use
The variable area flowmeters are suitable for measuring gases, vapours and liquids.
These devices are particularly suitable for measuring:
• Liquids
• Hydrocarbons
• Water
• Chemicals with low corrosiveness
• Industrial gases
1.2 Certifications
The flowmeter meets the statutory requirements of the following EC directives:
• Pressure Equipment Directive 97/23/EC
• EMC Directive 2004/108/EC for instruments with electrical options
• ATEX Directive 94/9/EC for instruments in Ex-areas
The manufacturer certifies successful testing of the product by applying the CE mark.
CAUTION!
Responsibility for the use of the measuring devices with regard to suitability, intended use and
corrosion resistance of the used materials against the measured fluid lies solely with the
operator.
INFORMATION!
The manufacturer is not liable for any damage resulting from improper use or use for other than
the intended purpose.
DANGER!
For devices used in hazardous areas, additional safety notes apply; please refer to the Ex
documentation.
WARNING!
The operator shall bear sole responsibility for the use of the flowmeters with regard to
suitability, intended use and corrosion resistance of the materials used to the medium.
The manufacturer shall not be liable for any damage resulting from improper use or use for
other than the intended purpose.
Do not use any abrasive or highly viscous media.
CE marking
MA_VA40_45_R04_en_424402_PRT.book Page 5 Monday, September 16, 2013 8:50 AM