KEPCO KIT 219-0527, Cable Kit - BOP 26600, 2 in Series - Manual

©2012, KEPCO, INC
Data subject to change without notice
228-1633 REV 3 051412
I N S T R U C T I O N S H E E T
KEPCO
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
An ISO 9001 Company.
CABLE
219-0527
KIT
CABLE KIT NO. 219-0527
BOP 26600 MODELS (2) IN SERIES
I. DESCRIPTION.
This kit contains the cables and terminations required to operate two identical 750 Watt Model 26600
BOP power supplies in series, effectively doubling the output voltage capacity.
Refer to the associated technical manual supplied with the BOP Model 26600 power supply for all
instructions regarding installation and operation of multiple units in series.
. CAUTION: Failure to install the ground cable supplied can result in damage to the power supply.
II. SPECIFICATIONS
Table 2 lists the general specifications for the series combination of two identical 750 Watt Model 26600
BOP Power Supplies. For specifications not listed in Table 2, refer to the General Specifications pro-
vided in the associated technical manual supplied with the Model 26600 BOP power supply
TABLE 1. EQUIPMENT SUPPLIED
Item Quantity Purpose
Kepco Part
Number
Output Power cable
(1.5 ft.)
1
Connects the OUTPUT terminal of Master to the COMMON terminal of
Slave.
118-1112
Protection Cable
(1 ft.)
1
Provides interlock protection signals required for multiple unit operation.
118-1126
Series Control cable (1.5 ft.) 1 Provides control signals required for series operation. 118-1120
Series Sense cable 1 Connect OUT-S terminal of master to COM-S terminal of slave. 118-1271
Protection - OUT Termina-
tion (Slave)
1
Provides proper termination for the slave connection to the Protection
Cable.
195-0108
Protection - IN Termination
(Master)
1
Provides proper termination for the master connection to the Protection
Cable.
195-0107
Instruction Manual 1 Lists material supplied and specifications for multiple unit combination. 228-1633
Chassis Ground Cable 1 Connects chassis ground terminals of all units. 118-1272
Ground Cable mounting
hardware
2 sets Each set consists of eight parts, mounted in the following order: No. 10 star
lockwasher P/N 103-0106 (at chassis), No. 10 flat washer P/N 103-0031,
No. 10 split lockwasher P/N 103-0033, 10-32X3/8 nut P/N 102-0008, No.
10 flat washer P/N 103-0031, [lug(s) from ground cable], No. 10 flat washer
P/N 103-0031, No. 10 split lockwasher P/N 103-0033, and 10-32X3/8 nut
P/N 102-0008. (See Purpose
at left for part
numbers)
!