KEPCO KIT 219-0443, Kit for connecting two 1000W BOPs in Series - Manual

©2012, KEPCO, INC
Data subject to change without notice
228-1486 REV 2 033012
I N S T R U C T I O N S H E E T
KEPCO
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
An ISO 9001 Company.
CABLE
219-0443
KIT
CABLE KIT NO. 219-0443
BOP 1000W MODELS (2) IN SERIES
I. DESCRIPTION.
This kit contains the cables and terminations required to operate two identical 1000 Watt BOP High Power mod-
els in series, effectively doubling the output voltage capacity. Only identical models may be configured to operate
in series.
This kit can be used with all 1000W BOP models that have revison levels as shown in Table 1. Earlier models that
have been upgraded to permit multiple unit configurations must include the letter “A” following the revison num-
ber.CAUTION: Failure to install the ground cables supplied can result in damage to the power supply.
Refer to the associated technical manual supplied with the High Power BOP power supply for all instructions
regarding installation and operation of multiple units in series.
II. SPECIFICATIONS
Table 3 lists the model parameters unique to a series combination of two identical 1000W BOP Power Supplies.
Table 4 lists the general specifications for the series combinations listed in Table 3. For specifications not listed in
Table 3, refer to the General Specifications provided in the associated technical manual supplied with each
1000W BOP power supply
TABLE 1. REVISION LEVELS APPLICABLE TO THIS KIT
Model Revision
Revisions for Upgraded Units
(Must include “A”)
BOP 6-125MG All All
BOP 10-75MG 5 or higher 3A or 4A
BOP 20-50MG 8 or higher 5A, 6A or 7A
BOP 25-40MG All All
BOP 36-28MG 11 or higher 8A, 9A or 10A
BOP 50-20MG 7 or higher 5A or 6A
BOP 72-14MG 7 or higher 6A
BOP 100-10MG 6 or higher 2A or 4A
TABLE 2. EQUIPMENT SUPPLIED
Item Quantity Purpose
Kepco Part
Number
Output Power cable
(1.5 ft.)
1
Connects the OUTPUT terminal of Master to the COMMON
terminal of Slave #1.
118-1112
Digital Control (Bitbus)
Cable (1 ft)
1 Provides communication between master and slave. 118-1108
Protection Cable
(1 ft.)
1
Provides interlock protection signals required for multiple unit
operation.
118-1126
Series Control cable
(1.5 ft.)
1 Provides control signals required for series operation. 118-1120
!