KEPCO DIN KIT ECM (S) - Manual (Page 2)

2
228-1334 REV 1 061801
KEPCO, INC. " 131-38 SANFORD AVENUE " FLUSHING, NY. 11352 U.S.A. " TEL (718) 461-7000 " FAX (718) 767-1102
http://www.kepcopower.com " email: [email protected]
2. INSTALL CLIPS. Snap the two clips into the mounting plate holes (see Figure 3).
FIGURE 3. INSTALLING CLIPS ON MOUNTING PLATE
3. INSTALL POWER SUPPLY ON DIN RAIL. To mount the power supply on the rail insert one end of both
clips under one edge of the rail, then snap the other end of the two clips into place (see Figure 4A).
REMOVING POWER SUPPLY FROM DIN RAIL. While grasping the power supply with one hand, Insert a screw-
driver into the access holes provided and apply leverage towards the left as shown in Figure 4B to disengage
each clip from the rail. Where mounting clips are close together, it may be necessary to apply leverage with two
screwdrivers simultaneously.
FIGURE 4. INSTALLATION AND REMOVAL OF POWER SUPPLY FROM DIN RAIL
FIGURE 5. POWER SUPPLY WITH KIT INSTALLED, OUTLINE DIMENSIONS
B
REMOVAL INSTALLATION
A