Autostart AS-6250V User Manual

Page 8

P. 8

User Guide

4. Flash twice again.

Panic Mode

Safety feature: Activate Panic Mode in an emergency situation.

In an emergency situation, you can activate Panic Mode using the

LOCK

UNLOCK

STOP

button. This will:

Shut down the engine,

Unlock the doors (if

UNLOCK

pressed)
Or lock the door (if

LOCK

is pressed),

Disarm the Starter Kill and

Activate the siren for 1 minute.

(See below for a description of the Starter
Kill.)

To activate Panic Mode

Press and hold the

STOP

button for approximately 3 seconds until the siren starts to sound

and the parking lights flash
Or press and hold the

UNLOCK

button for approximately 3 seconds until the siren starts to

sound and the parking lights flash: this will unlock the doors before the siren sounds.

Or press and hold the

LOCK

button for approximately 3 seconds until the siren starts to

sound and the parking lights flash: this will lock the doors before the siren sounds.
Panic Mode will automatically shut down after 1 minute.

Note

: To stop Panic Mode before the 1-minute delay, press the

LOCK

UNLOCK

button until

the siren stops.

Quick Lockout

(Also called Secure Panic.) For fast protection, the system will

LOCK

all doors when you

press the brake pedal while the siren is sounding. (Quick Lockout is only available
when Panic has been activated.)

Cold Weather Mode

If your vehicle has a Manual transmission, Ready mode should be set before entering

Cold Weather. When the Cold Weather Mode is active, the engine starts every 2 hours

and runs for 3 minutes (or for 8 or 20 minutes with Diesel engines); the routine will go on

for a period of 24 hours.
To enter Cold Weather Mode:

Press and hold the

START

button for 3 seconds until the parking lights flash 3 times.

(If Safe Start is enabled, the

START

button must be pressed beforehand – see below.)

To enter Cold Weather Mode if Safe Start has been activated:

Press and hold the

START

button for 3 seconds until the parking lights flash 3 times.

To exit Cold Weather Mode, do any one of the following:
Open the hood.

Start the engine using the remote control.

Turn the ignition key to the

IGNITION ON (RUN)

position.

Press and hold the

START

button for 3 seconds. (The parking lights will flash once.)

To check whether Cold Weather Mode is active, press and release the brake pedal: the

parking lights should stay on while your foot is on the brake pedal.