beautypg.com

Autostart AS-6250V User Manual

Page 10

background image

P. 10

User Guide

Remote Door Locks

If your system was installed with the Remote Door Locks option, you will have the

convenience of remote keyless entry.
To

UNLOCK

your doors and

DISARM

the system:

1. Press and hold the

UNLOCK

button for approx. 1 sec.

2. The parking lights will flash twice and the LED will go out to confirm that the

doors have been unlocked, that the Starter Kill feature is disarmed (if it was

installed) and that the Alarm is disabled.

To

LOCK

your doors and

ARM

the system:

1. Press and hold the

LOCK

button for approx. 1 sec.

2. The parking lights will flash once and the LED will flash slowly to confirm that

the doors have been locked, that the Starter Kill feature is enabled (if it was
installed) and that the Alarm is armed.

Passive or Active Arming

By default, the system is configured to Passive Arming Mode. In Passive Arming Mode,

the Starter Kill and the Alarm will automatically arm 30 seconds after the last door is

closed. The system will not arm itself if a door is left open.

Important note: When the system re-arms automatically or if there is an Alarm condition, you
can disarm the system by simply pressing the

UNLOCK

button.

Disarmed Notification

(

OFF

by default.) This feature will notify the user when the vehicle was left disarmed: after

the Engine has been shut down and all doors have been closed, after 10 seconds the

horn will honk once if the doors have been left unlocked.

Shock Sense And Warn-Away Sense

(Both enabled by default.) This system can react to a full shock by triggering the Alarm; it
can also respond to a lighter shock (30 % of the strength of a full shock) by giving a

warn-away (without triggering an Alarm condition). When the Engine is running after a

remote start, however, the system will prevent any Alarm condition to be triggered ;

it will still give a warning sound if warn-away is enabled.

Siren Chirps

(On by default.) The siren will chirp to confirm the system‘s basic operations:
By default, when the doors are being locked the siren will give one chirp if none of the

zones are active.

If a zone is active as the doors are being locked, the siren will give three chirps.

When the doors are being unlocked, the siren will give two chirps if no intrusion was
detected.

If an intrusion was detected, as the doors are being unlocked the siren will give four

chirps.

The system can alternatively be set to:
Warning Mode (no chirp during lock/unlock – unless a zone is active when locking, in

which case there will be 3 chirp upon locking – or unless the alarm was triggered, in

which case there will be 4 chirps when unlocking);