Autostart AS-6250V User Manual
Page 12
P. 12
User Guide
If your vehicle has an automatic transmission, proceed as follows to set the system in
Turbo Mode
:
1. With the engine already running, press the
LOCK
button on the transmitter until
the parking lights come
ON
.
2. Remove the ignition key from the ignition switch. The engine will go on
running.
3. Exit the vehicle and close the door.
4. Press the
TRUNK
button to lock the doors; the engine will shut down after
60 seconds of Turbo Mode.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine,
to activate Turbo Mode:
1. Ensure that all the doors are closed and that the shifter is in the neutral
position.
2. With the engine already running, apply the parking brake and release the brake
Pedal.
Make sure to release the brake pedal.
3. Within 20 sec. Press
LOCK
,
UNLOCK
or
START
on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
a.
LOCK
to lock the doors and shut down the engine after 60 sec.;
b.
UNLOCK
to unlock the doors and shut down the engine after 60 sec.;
c.
STOP
to shut down the engine immediately, without affecting the doors (this will
bypass Turbo Mode).
d.
TRUNK
TO SET THE VEHICLE INTO IDLE MODE
Engine Run Time
If you have a gas engine, your system can be programmed to run the engine for 3, 15, or
25 minutes (15 min default). If you have a diesel engine, it can be programmed to run the
engine for 8, 20, or 30 minutes (20 min default).
Extended Run Time
With the vehicle running under a remote start, pressing and holding the
START
button for
more than 1 second will reset the run time counter to zero and restart the run time cycle
from the beginning.
To stop the vehicle, at any moment, simply press the
STOP
button. This procedure can
only be carried out once per remote start.
Example: if your Module is programmed for a run time of 3 minutes and your vehicle has
been running for 2 minutes already, pressing the
START
button will reset the counter to
zero and the Engine will run for another cycle (in this case, 3 minutes).