beautypg.com

Autostart AS-6250V User Manual

Page 5

background image

User Guide

P.

5

quickly and remain lit.
Skip to step 4.

3. Within 20 sec. of engaging the parking brake,

press and hold

LOCK

,

UNLOCK

or

START/STOP

on the transmitter.

The parking lights will flash 3 times
quickly and remain lit.

-

4. Remove the key: the engine will continue running.
5. Exit the vehicle and close all doors, hood and trunk.
6. Press for approx. 1 second either:

LOCK

to lock the doors and shut down the engine;

UNLOCK

to unlock the doors and shut down the engine;

START/STOP

to shut down the engine without affecting the doors.

Remote-starting

Press the

START

button for approx. 1 second. The parking lights will come

ON

, informing

you that the unit has received your signal. The engine will start approx. 5 seconds later.

The parking lights will remain

ON

during the pre-programmed run time.

If the vehicle doesn’t start at the first attempt, the system will shut down.

If your vehicle is

equipped with an automatic transmission, there will be 3 start attempts before the system

gives up.
Vehicle Presets

Heater & Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in

preparation for the next remote start. Settings for the blower motor (fan), front and rear,

as well as heated seats (if equipped) should not be left on

HIGH

. It is recommended to

leave the settings on

LOW

or

MEDIUM

instead.

Windshield Wipers & Radio & Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to
become energized while running under remote start. When leaving the vehicle you must

ensure that the windshield wiper and headlight switches are

OFF

. Leaving the headlight

switch

ON

on certain vehicles could cause them to remain

ON

even after remote starter

shut down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press the

UNLOCK

button to

DISARM

and

UNLOCK

the doors. Enter the vehicle and do the following:

Turn the ignition key to the

IGNITION ON (RUN)

position. (Do not turn the key to the Start

position while the engine is running. This will cause the starter motor to re-engage.)
Press the brakes to disengage the remote starter unit.

You are now ready to drive off.

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.

This feature allows you to let the remote starter take over control of the vehicle (i.e. no

Key in the Ignition Switch) while the engine is running. For example, if you stop for a