HT instruments HT5000 User Manual

Page 19

HT-5000

EN - 18

4.3.1.3 Changing of the system settings

Proceed as follows to change the settings:

Step Action

Briefly press the

button while continuing to hold down the

key

until an audible signal is heard. The following image is display:

Now one of the following depth measurement processes may be
selected by pressing the

key:

Select this symbol if you want to determine the depth of a
probe which has been pushed into a non-metallic pipe

Select this symbol if you want to determine the depth of a
line, the signal of an active transmitter is coupled onto

Now a unit of length used by the system may be selected by pressing
the

key:

Feet (ft)

Metre (m)

Press the

key to save the settings. The changes will remain in

effect even after the receiver is switched off and back on again

Proceed as follows to change the receiving frequency of operation modes with more than
one possible frequency:

Step Action

Briefly press the

key while continuing to hold down the

key until

an audible signal is heard. The selectable frequencies are now visible
in the display:

Use the

and

keys to switch between 50 and 60Hz. The active

setting is marked with a black background

Press the

key to save the settings. The changes will remain in

effect even after the receiver is switched off and back on again