HT instruments HT5000 - Manual (Page 11)

HT-5000
EN - 10
4.2.2.2 Coupling with special accessories
The signal from the transmitter can be directly coupled into plug sockets, antenna
connections coax and telephone jacks with the aid of a suitable adapter cable (Cod.
890008852
). In doing so, it is not necessary to disconnect the lines.
Fig. 5: Couplng via adapter cable
The transmitter signal can be coupled onto easily accessible cables with the aid of a
100mm transmitter clamp (Cod. 820005314). In doing so, it is not necessary to disconnect
the cables
Fig. 6: Coupling via transmitter clamp
By ensuring that the transmitter clamp is completely closed around the cable, only a small
leakage field will be generated. This can significantly reduce the unwanted coupling of the
signal onto neighbouring lines.
Ideally the cables will be grounded at both ends, but even if they are not grounded at one
end, selecting high power transmitter output will assist easy location