Fire-Lite PRN-6 Operators Manual - Manual (Page 18)

Settings (I)
➤ Setting the tear
position If the tear position of the paper is not aligned with the tear edge of the printer, you can adjust it.
Press the Setup key. The printer changes to Setup mode.
Press the Adjust key.
Press the Tear key.
Press the < or > key to move the perforation to the appropriate position.
Confirm the setting by pressing the Set key. The printer returns to its initial status.
The correction made (a maximum of approx. 2.5 cm [1"] in both directions) will be retained
after printer power-off.
➤ Setting the first
printing line (TOF) You can use the TOF function to set the position of the topmost printing line individually for
each paper source and each menu.
You should adjust the tear position (see above) before using the TOF function (when using fan-
fold paper).
Press the Setup key. The printer changes to Setup mode.
Setup
Online
Offline Trac.1
Park LF/FF
Setup
Online
Adjust Paperway
Menu Char
Setup
Online TOF
Tear
Setup
Online
TearAdj=00/72" *
Set Exit
Setup
Online
Adjust Paperway
Menu Char
Settings (I) Quick start-up
16