Fire-Lite IPDACT-2 - Manual (Page 35)

IPDACT-2(UD) - Configuration
III-32
Doc.DM385-I
Rev. 4.0
The register is made up of four fields corresponding to the 4 numbers of the IP
address; this admits values between 0 and 255. Each number has a
verification digit. The default value is:
000 000 000 000
Alarm encryption key for the IPDACT-2(UD) to the maintenance receiver
This is the key used by the IPDACT-2(UD) to send alarms to the Teldat
maintenance VisorALARM. So the configuration is valid, this must be
repeated twice.
The registrar consists of one field with up to 16 DTMF digits. By default, no
value is configured.
Autoregister password
This is a password for the IPDACT-2(UD) to perform a delayed registration in
the configured VisorALARM receiver and consequently get the full
configuration parameters needed for operating purposes.
It must match the Installation Password defined in the Configuration Patterns
in the VisorALARM receiver that corresponds to the parameter set that must
be downloaded in the IPDACT-2(UD).
From this moment the IPDACT starts trying to connect the VisorALARM to
complete registration and start operating.
While the IPDACT is in the auto-registering process, LED A flashes green.
When the registration has completed, LED A stops flashing and LED E lights
up in green.
Using the testing digits
In order to increase the reliability of the telephonic console, some registers
require an additional testing digit in each of their fields so that if the control
digit does not adjust to the introduced value, the data is considered invalid
and an error tone is emitted. This facility can be enabled or disabled through
this register.
The register is made up of a single digit field which admits a value of 1 to
activate the use of the testing digits and value 0 to deactivate. The fields
contain a verification digit for the number. Default value is 0.
III - 3.1.3. Minimum configuration for the installer
By using the configuration patterns in the Teldat VisorALARM, you can
simplify the IPDACT-2(UD) installation process. So that the whole of the
process is possible, it is essential that there is a configuration pattern
configured in the VisorALARM. In the pattern, an installer password is
associated to a given IPDACT-2(UD) configuration. This configuration