Fire-Lite IPDACT-2 - Manual (Page 28)

The process for this is as follows: 1) switch off the IPDACT-2(UD), 2) short
circuit the P1 jumper, 3) switch on the device, 4) maintain the P1 short
circuited during the first burst from LEDs A, B, C and D (they light up and
switch off consecutively) and open it half way through the second burst. If the
process has executed successfully, the IPDACT-2(UD) will display a third
burst indicating the default configuration has been activated.
III - 3.1.2. Register description
IPDACT-2(UD) IP address and mask
IP address and mask associated to the IPDACT-2(UD) in order to operate in
the client’s local network. From IPDACT-2(UD) software release 2.0 onwards,
this parameter is only necessary in cases where you do not have a DHCP
server or as a backup configuration in cases where the said DHCP server is
down.
The register is made up of 8 fields; both the IP address as well as the mask is
composed of 4 numbers between 0 and 255. Each number has a verification
digit. This contains the following value by default:
192 168 000 100 255 255 255 000
IPDACT-2(UD) access Gateway
IP address associated to the access gateway in the client local network. This
gateway gathers all the traffic from the IPDACT-2(UD) and ensures that it
reaches the next hop to the Teldat VisorALARM. From IPDACT-2(UD)
software release 2.0 onwards, this parameter is only necessary in cases
where you do not have a DHCP server or as a backup configuration in cases
where the said DHCP server is down.
The register is made up of 4 fields corresponding to the 4 numbers in the IP
address; this admits values between 0 and 255. Each number has a
verification digit. This contains the following value by default:
192 168 000 200
Access password for the console
Access password for the telephonic console which prevents unauthorized
access. This is also used to verify some operations. This must be entered
twice in order to validate it.
The register is made up of one field with up to 16 digits. The default value is
24680.
The password field cannot be left empty.
IPDACT-2(UD) - Configuration
III-25
Doc.DM385-I
Rev. 4.0