Detcon Sensor Duct Mount Kit FP/TP/DM/IR Series - Manual (Page 5)

1.2.2 INSTALLATION
1 - Cut clearance hole in duct as shown below. Cutout is the same for square or round ducts.
2 - Mount the duct mount kit using four 1/4” sheet metal bolts or other appropriate hardware.
3 - If necessary you may enhance mounting integrity by using the two holes on the upper right portion of
the duct mount plate. Use standoffs and 1/4” sheet metal bolts or other appropriate hardware.
4 - Perform installation wiring as described in the sensor assembly instruction manual. Use f lexible conduit
to allow for future maintenance.
Detcon Duct Mount Kit PG.5
4.25
3.125
Cut Out
Cal Port
HOUSTON, TEXAS
detcon inc.
Duct Mount Kit
11
7
5 1.5 .5
3
.5
1.4
5.5