Detcon FP-624D - Manual (Page 18)

Model FP-624D
FP-624D Instruction Manual Rev. 1.2 Page 14 of 42
3.2 Operator Interface
The operating interface is menu-driven via the two magnetic program switches located under the target marks
of the sensor housing. The two switches are referred to as “PGM1” and “PGM2”. The menu list consists of
three major items that include sub-menus as indicated below. (Refer to the complete Software Flow Chart.)
Normal Operation
Current Reading and Fault Status
Calibration Mode
AutoZero
AutoSpan
Program Mode
View Sensor Status
Sensor Model Type
Current Software Version
Range of Detection
AutoSpan Level
Days Since Last AutoSpan
Remaining Sensor Life
Sensor Bridge Current
Sensor Bridge Voltage
Gas Factor
Cal Factor
mA Output
Input Voltage Supply
Sensor Temperature
Serial ID
Alarm 1 Level
Alarm 1 Ascending
Alarm 1 Latching
Alarm 1 Energized
Alarm 2 Level
Alarm 2 Ascending
Alarm 2 Latching
Alarm 2 Energized
Fault Latching
Fault Energized
Set AutoSpan Level
Set Gas Factor
Set Cal Factor
Set Bridge Voltage
Signal Output Check
Restore Default Settings
Set Serial ID
Alarm 1 Settings
Alarm 2 Settings
Fault Settings